Fitting your Raspberry Pi 4 to our modular case requires you to push the Raspberry Pi into the case a certain way.
Fitting
Start with the USB/Ethernet ports - hold the middle USB ports and pull them into the USB/Ethernet holes. Once the USB ports are through, the HDMI/audio ports will click into place and the Raspberry Pi will slot down into position - you can now use the included screws to secure it in place.
Removal
To remove your Raspberry Pi, start by lifting the board up, and then apply pressure to the Raspberry Pi's 3.5mm audio port from outside of the case - this will give it just enough movement to click out of the case, allowing you to remove the board.